PROJECT DATA

Schuler Innovation Tower S.I.T. designed to become a local Landmark

Project: New Schuler Innovation Tower (S.I.T.) at Schuler headquarters in Göppingen, Germany

Owner: Schuler AG, Göppingen

Contractor: Consortium Max Bögl Bauservice GmbH & Co. KG, Neumarkt and Peter Gross Bau GmbH, St. Ingbert, Germany

MEVA Systems: Wall formwork Mammut 350 with all-plastic facing alkus, Slab formwork MevaFlex, Project table forms

Engineering and support: MEVA Formwork Systems, Germany, Stuttgart and Munich branches

 
 
1
2
3
4
5
 

Project

Saving 4 Weeks on Schedule

Schuler AG is technological and world market leader in metal forming. Its headquarters are located in Göppingen, South West Germany. The company is investing in the Schuler Innovation Tower (S.I.T.), a 12-storey engineering and technology center that will become the working home to 750 staff members. At a height of more than 50 m, it will be a landmark in Göppingen and the town’s highest building.

The Max Bögl solution: narrow table forms for the open facade
The requirements for slab pours were clear: they had to be safe, fast and matched to the tower’s open facade. The solution: table forms, 5.40 m long to exactly fit into the openings between the columns. Short filler pieces with rounded edges provided a perfect match to the column layout. 28 table forms consisting of a wooden sheet on H20 beams plus a swiveling prop head were built for the job and provided the slab forming solution for the entire facade on one level. The stop end on the outer edge was done with a wooden board. Since the table forms are very narrow, they had to be secured using push-pull props. This also proved a simple, practical and fast answer to safety requirements. The contractor’s innovative approach was put into practice thanks to good planning and support by MEVA engineers in Munich and Stuttgart.

Simple transition to the MevaFlex slab area on the inside
The facing sheet stopped 5 cm short of the table forms’ inside edge, allowing a simple transition to the MevaFlex slab forming area on the inside of the building, saving time and effort. The main benefit of the table form method: speed! It allowed the contractor to speed up the schedule for slab works by an entire four weeks.

Round walls, narrow cores, staircases in architectural finish
The complex demands on the overall forming job were fulfilled thanks to careful engineering and planning by MEVA engineers. Efficiency is paramount, so rounded walls were achieved polygonally using rented wall panels with radius compensation fillers. Wall heights of 4.75 m with irregular edges were formed using Mammut 350 panels with just one extension.